I made a nice water pump system and it seemed wrong to use panel lights with it. So I went VFD…
![](https://es.pratt.edu/Commons/Images/laser%20v2/IMG_1383.jpg)
Fairly Simple design but I did add screw mounts for the display itself and a form fitting pocket…
![](https://es.pratt.edu/Commons/Images/laser%20v2/Screen%20Shot%202018-09-10%20at%201.02.00%20PM.png)
I even added an RGB led indicator
![](https://es.pratt.edu/Commons/Images/laser%20v2/Screen%20Shot%202018-09-10%20at%201.02.15%20PM.png)
![](https://es.pratt.edu/Commons/Images/laser%20v2/IMG_1368.jpg)
Not a bad fit..
![](https://es.pratt.edu/Commons/Images/laser%20v2/IMG_1369.jpg)
The hard part was cutting the panel. I was going to use the plasma cutter but I opted for an angle grinder with a cutoff wheel. I figured there would be less warping of the thin plate.
![](https://es.pratt.edu/Commons/Images/laser%20v2/IMG_1375.jpg)
Luckily the whole control panel drops out….
![](https://es.pratt.edu/Commons/Images/laser%20v2/IMG_1374.jpg)
![](https://es.pratt.edu/Commons/Images/laserv3/IMG_1379.jpg)
![](https://es.pratt.edu/Commons/Images/laserv3/IMG_1380.jpg)
Guess I need more water….
![](https://es.pratt.edu/Commons/Images/laserv3/IMG_1416.jpg)